When editing a switch thats set to midi, while Im editing which midi note goes to which channel, sometimes the software will crash. Also some midi notes stick. And don't know if this is midi caused or not, but while running a show at a club, they have 5 elation colorspot150s and I brought in a couple of leds, during the show all the lights went out (including the clubs 150s) and my lights were daisy chained off the 150s, the 150s were acting spratic and even when the dmx cord was plugged in the adresses were flashing as if nothing was plugged in, I tried connecting it to another controller and it still did the same thing, no signal. Could sending to many signals ever just make a cable go bad? It seemed the cable from the house to the 1st light was the issue, but I couldn't tell for sure as I left later that night.

Just did this again, and crashed more then 10 times. This is a huge problem, the software is completely unstable with MIDI, this was tried on another computer as well. Is this issue known?

send me the crash reports to jamesk at elation lighting DOT COM
Sincerely,

Thnx james, do the reports get stored anywhere when you don't have any net connection? I know I have one report saved in my drafts in outlook, ill send that over. Thnx

They should be in the sl2006 folder. Will say CRASH.

Thnx james, sending now! Also im buying the design led TRI's!

I'm late to the game here but I use 2 Akai MPD32's, an LPD8, and an LPK25 through a powered USB hub and she'll handle it fine. I had to get a better computer to be able to do this, though. On my older laptop, she didn't like multipe MIDI signals.