Skip to main content

I have a DS-250 ver 1.3 and the roto-gobo wheel moves back and forth in short turns, not making any complete rotations, and it will not adjust to any gobo position when using DMX signal. I've swapped magnetic sensors, the magnet is in the gobo wheel and it does detect home. I've also checked the stepper motor for smooth movement, although I can feel the 'steps' in it, but the other motors (that are working) feel the same way.
I am assuming the stepper motor is good, I've also checked the harness and to make sure all the plugs are seated well.

What would cause this problem? I'm assuming that the stepper motor IC might be suspect?
Original Post

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×