I had my wife buy this unit down in Florida and it had three error messages:
05, 06 & 07.

Each error could have multiple causes. EG, error coder 05

"This message will appear after a fixture reset if the color wheel’s magneticindexing
circuit malfunctions (sensor failed or magnet is missing) or there is a stepper motor
failure (defective motor or a defective motor IC drive on the main PCB)."

How do I isolate what the cause is for each?

Thanks for your help.

Detailed photo's or video would be greatly appreciated.

hello most likely it may be an issue with the head pcb (only because you have more than one error) please send me an email to Service@ elationlighting.com with your serial number and i will explain what to look for.

Best Regards,
Gines Gines

I switched out the head PCB board from a good unit and the errors remain
05ER, 06ER & 07ER.

What else should I try sir?

One more thing. While removing the Head PCB, one of the heatsinks fell off a chip. What kind of glue should I use to stick it back on?

hi sir, at this point i would suggest sending it in to service. this is rather strange.
let me know.

best regards,
Gines Gines
elation service manager