Hi I'm new to the form, Running the Operator 192 and four Dynasty Scans, having problems with the first light in line even when i switch scanners around. The first light lags behind sometimes, also it sometimes gets out of alignment, meaning when all four gobos are in line on the floor the first gobo is closer to scanner two's gobo, if i shut all scanners off and turn them back on it will then be in the correct position. I called American DJ they asked me what cable I was using I said 3 pin XLR mic cable they explained the difference between mic cable and DMX cable so I purchased the ACCU Cable and a terminator plug Im still having the same problems. Hope i was not that confusing, any help would be much appreciated
Thank you.

Sounds like a problem with your fixtures. so it would be more likely an ADJ issue rather than the controller. Definitely give ADJ service another call on monday. ill also forward this post to the ADJ service team. Sincerely,

DJ Young,
Make sure that Audio mode is off, on the Dynasty Scans.