Hi There!
I have a Elation AR-32RM and want to ask, is it possible to record specific range of the DMX link, for example only channels that are different from "0", not the whole 512ch?

Best Regards!

Dian Tuhchiev
ProTechnica Bulgaria

Subbass,
I'm not quite sure of what you are asking? The AR-32RM and software is basically a DMX recorder. It will only record the signal which comes out from your DMX controller in REAL time. If you can adjust these settings from your controller itself then the AR-32 should be able to record it.

RC

Ok, for example i have 10 RGB pixels(on dmx channels 1 to 30) and 10 moving heads(on dmx channels 100 to 320),so i want to record in a scene only info about RGB's, and in another scene only dmx channels for moving heads, and then combine these 2 scenes in a single show at the same time.

Subbass

That should not be a problem, if you are able to activate these 2 scenes on your DMX controller then you can press record on your AR-32RM it should record fine. As I had mentioned in my previous post. the AR-32RM is a DMX Recorder and will record any DMX signal which come out of your controller.