I bought the Copilot III at Best Buy yesterday, opened the boxes up and found a seven page stapled instruction booklet that doesn't tell you squat about how to operate it.

After about three hours the lights finally started to "chase" however using the audio selector doesn't really work very well.

It will work with the audio feed for about two and half minutes then stop.

So for the people who aren't lighting groupies can someone explain how I get this controller to actually stay with the audio feed?

quote:

Copilot III

It almost sounds like you have the controller set to manual mode and that is the built in scene running its course then stopping. try setting it to auto mode so it will run all 16 scenes automactically instead of running one scene then stopping. not sure how you are using it, but have you tried running a signal to the rca on the back from your mixer? if that is possible.I don't have one but that was my guess.