I have a lighting program put together using the Emulation software with roughly 6 scenes with anywhere from 2 to 11 cues per scene. I'm finding that I can run through the scences once without any problems, but if I run through them again, some of the cues are not functioning properly. Some of the lights won't come on at all, or they come on in a pattern that was not programmed. When I shut down the program and open it again, all of the scenes are as they should be and everything works fine. But only for one run-through.
Before running the scenes, I am clearing everything out twice as well as holding down the scene buttons until they go red. IS there another step that I am missing to clear out the program so I can start again without shutting down the program and re-launching? Can't figure out why i cant run through my programming more than once or revisit scenes without problems.
Original Post