Hi Xplitz,
It sounds like the lights are all set to the same address - so they are basically clones of each other, and will all do the same thing. Support is right about the address settings - it must be set correctly to control each light individually. The mistake here is that the DMX Operator has specific channel ranges per scanner. Scanner 1 = channels 1-16, Scanner 2 = channels 17-32, etc. So try setting your base addresses to D001, D017, and D033. That should get you individual control.
Make sure all 3 lights are set to DMX mode G - 15 channels. The DMX protocol for these lights is defined starting on page 29 of the manual.
For stand alone Master/Slave operation, make sure you follow the instructions on page 27-28 of the manual. First light set to master, the rest to slave. I would even consider inverting the pan/tilt on one of the slave lights to vary the show some more.
Hope this helps! Good luck!
Eaglejr
just another LD