Tagged With "Zoom"

Uses E-Loader uploader tool. Rayzor Q12 Zoom V1.1.6 Fixture Firmware What's new in V1.1.6: Enhanced Zoom calibration on the fixture menu display and added ability to do fixture reset on DC display power (battery powered) Rayzor Q7 V1.2.3 Fixture Firmware What's new: Fixed a slow movement bug in the software. You should not attempt uploading the firmware to the fixture unless you have read and fully understand the instructions that came with the relevant Fixture firmware uploader for your...

I’m having issues with some of my Zfx wash pros where they’re stuck at a specific zoom degree and won’t respond to controls. Does anyone have suggestions what may be keeping it from working? I’ve tried factory resetting and manually controlling the zoom from the fixture itself but no luck.

over time the small hex nut can tighten up causing the linear motors to bind. try backing them off 1/2 turn and retest. if not successful then the linear motor maybe fatigued and require replacement.

Where in the fixture is that hex nut/motor? The head, arms or base?

sorry it would be on the end of the linear motor itself, email parts at elation lighting . com and ill send a picture.

I went ahead and tried loosening the 3 hex nuts that half turn, but during testing I don’t see/hear any of the 3 the motors run at all. Would it be all 3 went bad at the same time or potentially something else in the board not sending power to those 3 motors?

I tried tracing the power lines but just making sure, the power for those 3 motors is on the backboard connected to J20-J22, correct?

check voltage at the linear motor, it is possible for all to go out since they work equally.

Uploader tool required: A-Loader Arena Zoom Q7IP Firmware V2.1 What's New: RDM Bug Solved. You should not attempt uploading the firmware to the fixture unless you have read and fully understand the instructions that came with the relevant Fixture firmware uploader for your fixture. Clicking this link will take you to the Software uploader section of our website so you can pick the correct uploader tool for your needs and fixtures. If you do not see your fixture listed, please contact ...