Skip to main content

Tagged With "programming"

Everything
Topic

SD1 and Generic Dimmer pack programming

SquireDude ·
I have an SD1 that is working fine but I have recently purchased a couple of Optima Matrix Pro dimmer packs. THey are supposed to work in 1, 2, and 4 channel modes. They work in 1 and 2 channel modes but fail in 4 channel mode. I have contacted the seller but they have no answers. I have suggested several times that it may be my programming but they are not familiar with the SD1. I am creating it as a Generic Dimmer and assigning 4 channels to it. I have tried 4 different dimmer packs and...
Reply

Re: SD1 and Generic Dimmer pack programming

SquireDude ·
Hi, After multiple tests using either of the Generic Dimmers definitions… I found that one definition is only 2 chnl and the other definition is 3 chnls. Instead of defining it as a Generic Dimmer pack I used RGBW and now I have all 4 channels working fine. Thanks, Phillip
Reply

Re: SD1 and Generic Dimmer pack programming

Jingles8302 ·
Hi, this should all work fine, as long as the patch is correct and the packs themselves are in the correct mode and address, if it works in 1 and 2ch, it should work in 4ch.
Topic

Luma_Net Connection

ReyDej56 ·
Working on fixing/replacing Luma-net/Leviton 404CP Control panels. Having difficulty of programming from the panels, how can I use Show Designer2 to reprogram the lighting scenes program that are set already to the 404CP?
Reply

Re: Luma_Net Connection

Jingles8302 ·
The only way i can think of is if the panel you are programming into has DMX in and can record DMX. I imagine the SD2 is just to program once and then the other gear you mentioned is a controller panel/rack system?
Reply

Re: Luma_Net Connection

ReyDej56 ·
I think it relates to between DMX and Elation SD 2 setting with Luma-net 404CP, I was following the programming instruction from the 404, but perhaps it's also the setting within Elation program to accept 404. Thanks!
Reply

Re: Luma_Net Connection

Jingles8302 ·
The SD2 can't accept anything IN except midi. so any non-standard dimming systems with Multiplex where there is extra voltage on the line should not be used. I think maybe perhaps your questions should go to NSI as the SD2 is a standard DMX 512 controller console and you are having issue with the 404.
Topic

DMX512 protocol data sending and receiving C programming problem

Malisa Suntech ·
For the DMX512 protocol, the compiled data receiving program can never receive data. How to use DMX512 to control the data sending and receiving C program of the single chip microcomputer chip STC12C5410AD to control the LED light on and off?
×
×
×
×