Tagged With "SixPar"

Upload tool: C-Loader or USB Stick Six Par Z19IP Firmware V 1.07 What's new: Changed the term Master/slave to Primary and Secondary. You should not attempt uploading the firmware to the fixture unless you have read and fully understand the instructions that came with the relevant Fixture firmware uploader for your fixture. Clicking this link will take you to the Software uploader section of our website so you can pick the correct uploader tool for your needs and fixtures. If you do not see...

I have 2 of my Sixpar 100 lights that are flashing "Update wait" on the screens. I can not find any updates. Does anyone have any suggestions?

greetings, this typically means there is some data on the line and the fixtures are interpreting this as a pending update. remove from install and power back up, if you are getting the same read out then most likely the display is corrupted and will need replacing.

Hello! I have been working on cleaning and ensuring my Sixpars are functional at my work. I was given a solution to clean the instruments (it had ammonia) and I used it to clean them with permission from higher ups. I’m finding that my display screens are blinking specifically on the dmx address screen when they were fine before. Is there anything I can do to try and fix this, or did I just destroy the display and will need to order a new one?

To clarify, the power still works. I’m not getting any signal for the dmx.

Greetings, when the display is blinking this means there is not data... Please confirm data is being sent from the controller... if there is data present and the display flashes then you have blown the DMX driver and will need to replace the display.

I am having the same issue!

Cannot get the RDM to talk with my controller. Is it possible that Net3 needs the RDM ID changed? the controller can briefly see the fixture but then syncs out for a time then syncs back on but not long enough to see what the fixture is experiencing, ie. temperature etc.