Skip to main content

I ask because I started experiencing memory blanking after uploading a new fixture profile set. I'm able to load in an old saved show with an older fixture profile and my issue of losing everything seems to go away. When I try to load in a data show file created with a new fixture profile set and scenes/shows it shows it loading in on status bar but after turning it off and back on nothing is there (no profile data, not scenes, no shows). I can load in my new fixture profile and assign the channels. I can program scenes and shows. I can save out the data however when I turn the board off it loses everything and comes up with no fixture profiles, no scenes, no shows. I've also had it glitch while programing with the new fixture profile loaded where it will freeze and lock up or simply reset so blank again.

I've changed the internal battery and replaced the power supply. As stated in another post I wanted to try re installing firmware but since then I've reloaded the old data file and it seems to be holding it in memory and not glitching.

So can profiles be programmed incorrectly? I noticed the presets can be tricky if you want certain stop points (example, strobing the shutter slow, yet maintaining the variable values of strobing before and after that set point.

Anyone have these profiles?

Martin Wizard
Martin SCX500
ADJ QA Par38

scrowin@ gmail.com
Original Post

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×