Skip to main content

When I go to a different gig the only way I know to adjust the x/y for the new venue dance floor is a pain.

I clik on page,then settings, then channel, then high light one of the moving heads, clik on the x/y button on the right and adjust from there. Do you recommend "under movements" the circle, square,center or mouse (shift).

I have always wanted for one scene to shine up on the walls and ceilings, but with the way I an doing it all the scene's change, so they are ALL on the dance floor or All on the ceiling. I see on U Tube that other guys do what I want done. Is it the software I'm using or is there another way to set :example one or two scene's so they go to the ceiling or up on the walls????

If I set one of the moving heads to go up then every scene one the moving heads go up. I would like ONE SCENE to go around the room, not just one moving head on each scene.

Hope I'm explaning what I would like to do clearly. If possible, is there a video explaning that?

Thanks in advance.
Original Post

Replies sorted oldest to newest

Ya I did. Sorry.
Sounds like you can just create 2-4 switches and use only the XY channel for the positions you want and then update these 4 switches at the venue before you start. The advantage of using a switch is when using a switch and only turning on say in your case the XY channels then those XY channels are the only channels that will over ride any currently playing scene. Make sense?
Sincerely,

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×