Skip to main content

Will EZ Kling work with 3-wire LED tape?  I've successfully made a KlingNet connection from Arkaos GrandVJ which is reading the settings I entered on the device.  However, nothing is happening on my LEDs.  I'm using a WS2811 strip so there is no clock connection.  I'm making an assumption that EZ Kling can auto-detect though I can find nothing about it in the documentation.

Original Post

Replies sorted oldest to newest

Thanks.  Yes, I'm using true pixel tape.  It works with my Arduino board where I can address each pixel individually.  When I set the EZ Kling mode to "Klingnet RGB Tape" the first 26 pixels on the tape turn on white at full brightness.   Is there another application recommended by Elation that I can use to test if the network is working properly?

Thanks.  No, I don't have a DMX controller.  The reason I bought this item was so I could do lighting control without a DMX controller.  If I understand you correctly, the EZ Kling will work with LED strips that have only 3 wires so the clock line is not needed.  Right?  The documentation that came with it has very little info.  I may be able to figure it out if I could get more verbose info about the abilities and protocol for this unit.  I didn't find anything on your website.  Can you point me to some other sources for info about using the EZ Kling?  Thanks again

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×