Skip to main content

I am having trouble getting my Show Designer 2CF to recognize the fixture profiles from the CF Card. I unziped the file and saved all the fixture profiles on the memory card. Then put the memory card into the board and the board says that there are no fixtures or profiles. I'm not sure what I am doing wrong. Could you please provide me with any sugestions you have.
Original Post

I  created 2 fixture profiles using SD2Fixture program downloaded front the Elation website.  Once I created the profile I saved on the CF card with 8 characters file name.  We I insert  into the CF slot and try to load fixture profile from CF.  I received the message "File not found". Please assist.

 

Thank you

Last edited by Gan

I think you can use larger than 64mb but 2G might be too large. This unit was designed back when those cards were in common use. Elation used to have those 64mb in stock to send out when needed. If it were me, I would just buy the USB cable and use that, the cable is not expensive. The instructions with the file transfer program give the part number for the cable.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×