Replies sorted oldest to newest
I hope this all makes sense. We are pretty new to the whole stage lighting community so any advice is helpful. We run (14) LED lights, (4) Par Spots, & (2) Pin Spots. All of these light had profiles that were already in the board so they will not be hard to set back up. I was just hoping I was overlooking something before sending the board back for repair.
Thanks for you help.
If you can not add or select fixtures you've lost your light fixture profile. If the internal battery dies (small round battery like in a watch) and you turn power off you'll loose this profile. ULink (upload) new profile. Can find instructions on Elation support Downloads.
If the 260 cycles and does not load/boot up, then its a firmware issue.
If firmware is corrupt and 260 not responding:
Press and hold function buttons 1, 10, 20 and 24 and turn this unit on. Then send firmware file for the Magic 260 with the u-link. If you need firmware 1.04 (1.02) send message.