Skip to main content

In This forum you can discuss tips, tricks, and troubleshooting for Elation's Next Generation Compu Live software, "Compu Show".

Running Win 7 with Compu Show
Have tried both installing USB before and after installing the Compu Show software. No difference: "No interface detected" when loading the program.
Controlpanel>System>Device Manager>USB-controller shows:
"Intelligent Usb Dmx Interface (SIUDI8C, 32/64bits)"
What Can be the problem
Original Post

Replies sorted oldest to newest

No. Interface not connected
I have noticed during setup, when installing drivers only one driver is being installed.
See this screenshot - only one green checkmark.
According to manual there must be two check marks. True?
https://dl.dropbox.com/u/50157...20Show%20Drivers.jpg

Have also tried to install the program in XP compatible mode and in Windows 7 mode. Makes no difference what so ever.
I have two laptops running Windows 7. Same behavior on both. Software AND the same USB interface runs fine with no problem on my XP workstation.
just received the "Compu Art SD" today.
load the software "Compu Show beta"
run the installation without the USB plug-in.
after software successfully installed, plug-in the USB and start the "Tool.exe"
Able to transmit DMX via the "Tool.exe" GUI.
update the firmware to 1.19
After which start the "Compu Show beta"
but could not get the interface connected.....

Help....
Hi , I HAve the same Problem than Ole Barnholdt
Running Win 7 64 BITS with Compu Show
Have tried both installing USB before and after installing the Compu Show software. No difference: "No interface detected" when loading the program.
Controlpanel>System>Device Manager>USB-controller shows:
"Intelligent Usb Dmx Interface (SIUDI8C, 32/64bits)"
ELATION SHOW COMPU SDE 2013 WITH THE NEW SOFTWARE BETA

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×