Skip to main content

I have a few DS 575e fixtures with a migrating or crooked screw beneath the rotating base of the yoke, that obscruct the disc from passing them as the light does its reset dance.
I was wondering if there was a practical approach, or even an impractical one to getting this cleaned up, the screws im talking about you can see the brothers of on the base of the light, there are 6, they screw into 6 corresponding posts that lead up to the problem screws.
My problem is they are extremely hard to get to, and the other light i sent out with this exact same problem, the repair may cost more than its worth because of the effort to get at this little guy.
Any one who has seen this, or even figured out a way past it, any feedback would be great!! Thanks!
Original Post

Replies sorted oldest to newest

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×