Skip to main content

Replies sorted oldest to newest

a gobo error can have multiple causes, first check to see if the magnet is present, also check the magnet /sensor orientation as well.  also make sure the gobo is in its correct spot.  if not successful check continuity from sensor harness to driver. if the problem persists check the PCB. lastly physically check the rotation and make sure the stepper is ok.





regarding shutter, are you able to physically open the shutter (make sure the unit is unplugged) if not then the stepper may have seized

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×