Programming adj lights

lauraleeMember

I am new to this forum and was wondering if anyone can be of help. I posted on the American dj forum, but I thought this could be an issue of elation since I am using the elation show designer 1. I don't use a computer program, just the elation board.
I have 2 of the ADJ Vizi Spot LED Pro lights that we use at Church. I was wondering if you can program these lights to move within a scene using the Elation Professional Show designer 1? I would like them to just stroll the room (along the edges) for an event, using the star gobo. If I can finally figure out how to do this there would be other events they could be used to do this for as well. I know that there are pre-programmed movements on channel 12, but I want something more specific than those, especially if I just want them in a line strolling.

Any help is appreicated!

Lauralee

7/21/123:19 PM

❤️ 0

Original Post

Replies sorted oldest to newest

Jingles8302Admin

I've moved your post to the show designer series forum section. One of the SD console guys will post a reply to your question probably sometime Monday.

Welcome to the forums.
Sincerely,

7/21/123:27 PM

❤️ 0

sdmanMember

Make a chase that does what you are describing and include that chase in a scene. Try a 4 step chase that points the lights at opposite corners of the room at each of the 4 corners. Set the speed to slow and fade rate at 100%. The two lights should move along the sides. You can have them move in opposite directions or in the same direction. If you do it with 2 chases you can even run the 2 lights at different speeds.

7/21/124:03 PM

❤️ 0

lauraleeMember

Thanks for the info! I tried to do that this morning, but I can't get the adj vizi spot led pro to move in the chase. What am I doing wrong or not doing?

7/22/1210:49 AM

❤️ 0

sdmanMember

Do you have control of all the Vizispot parameters? Can you select them and make them do something? If so, read the instructions on how to make a chase. Make 4 chase steps where the spots point to each of the 4 corners of the room.

7/22/1211:12 AM

❤️ 0

lauraleeMember

Thanks, i got them to work tonight. I have another quick question if you don't mind. I want to position a cross gobo over a cross on the wall is there a more precise way of doing this? I cannot get it centered the way I want. I don't like using the joystick I feel it's more sensitive, so I use channels 1 & 2 to move them.

7/22/125:46 PM

❤️ 0

sdmanMember

I'm not familiar with that light, some lights have rotating gobos that let you line that up just right. If it has a fine pan and tilt channel, use those for final alignment. The faders are easier than a joystick for fine adjustment.

7/22/127:15 PM

❤️ 0

Skip to main content

Add Reply

Membership Required

Remove From Your Block List

Manage Follow Preferences

Block

Please wait...