I cannot figure out how to make this setup work. The enode does not indicate that it sees the SACN network. IP set to 192.168.1.X/24 on all devices.
Replies sorted oldest to newest
Can you try the 2.x range for the IP address?
Ive switched to the 2.x range with no change.
What is the software version on your ENODE?
Is the activity LED flashing? What type of controller are you using? Can you try setting it to Artnet and trying Artnet to see if Artner works? Make sure you set the net mask to match your controller? Also make sure your port settings are set as well. Specifically port status, net and pricinpal. Please try out Artnet and let us know if Artnet works.
Artnet is working, kind of. Here is an overview of where I'm at:
The activity light is blinking rapidly, almost solid. Previously it was occasionally blinking but not rapidly.
-enode IP is 220.127.116.11 with subnet of 255.0.0.0
-Vista/Controller/Computer IP is 18.104.22.168 with subnet of 255.0.0.0
-Port 1: STATUS= Out, MODE= Single, FRAMERATE=30, NET=001, PRINCIPAL=001, SECONDARY=009
-Port 2: STATUS= Out, MODE= Single, FRAMERATE=30, NET=001, PRINCIPAL=002, SECONDARY=010
According to the Port Status display on the enode, Port 2 shows network connectivity while port 1 does not.
The enode shows up in Vista as connected with a Sub: 0 and Uni:1, assigned to universe 1.
I have control of fixtures in universe 1 when plugged into port 2 of enode.
I have not had any success with sACN. I ultimately do want to use sACN instead of artnet.
One more question what type of switch are you using to power up the ENODE 2 POE?
Unifi Switch 8-60W
Can you take a quick video of your settings on both your controller and ENODE 2 POE and send it to email@example.com please?
@Rafael C. what was the resolve here? I’m having the same issue, but with an enode 4. I assigned port one to universe 1, port 2 to universe 2, port 3 to universe 2, and port 4 to universe 3. I have two home runs on universe 2, so that’s the reason for two ports on same universe. In vista, my fixtures are showing up as being patched to port 1, but on their separate universes. It doesn’t specifically mention that it’s port one on the node, however I am getting fixtures on universe 2 and 3 controlling fixtures on universe 1. Not real sure what’s going on here.