Skip to main content

So I went into record mode (Record LED came on) and tried to enter DMX assign mode (REC+666) but nothing changed: display shows fader percentage (00). Up/Down buttons do nothing. Pressing "Rec" increments a number on the display. Tried DMX reset (REC+777) which worked but assign still doesn't work.
The 6 button works correctly as it's needed to enter record mode.

So now I've reset the DMX assignments and can't set it back! Any suggestions welcome.

Desk is 24 channel SceneSetter with the square buttons
Original Post

Benben... I also have been dealing with DMX addressing. My board is new. I did find i the manual (3.7)while in the record mode to hold record and then hit the #6 flash button 3 times which does not work. I did see, however, on the bottom of my controller that to enter the DMX addressing you have to hit Flash 8 (not 6) three times ..... The does allow me to enter the DMX channel addressing but I find nowhere how to program it in... I believe my unit is defective and I am in the process of getting a replacement.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×