Skip to main content

Tagged With "Branch"

Everything
Topic

Elation DMX Branch 4

Jack B ·
I'm using an Elation DMX Branch 4. Each output channel has 2 connectors, a 3 pin and a 5 pin. Can I connect DMX circuits to both connectors on a single output channel, or should I use only one?
Reply

Re: Elation DMX Branch 4

ELA GINES ·
Greetings, only use one (either/or)
Topic

Opto Branch 6 RJ45 (Discontinued) Tech Question

Martin B ·
I am having an issue getting a new network (Artnet/sACN/RDM to DMX) ethernet interface ouput to play nicely with our installed Opto Branch 6. DMX signal to the unit is intermittent and sometimes non-existent even though the controller software (Lightkey) and the interface box show consistent and expected DMX output. I am working through verifying the pinouts (3pin to RJ45 on Cat5 adaptor) at the output side of the box but I have also come across the possibility of setting a DMX frame rate...
Reply

Re: Opto Branch 6 RJ45 (Discontinued) Tech Question

Jingles8302 ·
Hi, i would try turning the terminate to on or off depending on where it currently is at and also try turning off RDM to see if that helps with these issues before adjusting the framerate of the DMX signal.
×
×
×
×