Tagged With "pan"

Ok I will do thanks

Hi! Whenever I try to fade some scenes and switches on my design spot 250 pros they do a position reset before going to the next position. Now, most of my scenes do these but two of them don't. This happens when my pan changes but not my tilt in these scenes any help is appreciated.

hi when you say position RESET do you mean like when they first power on? Like a full XY re-home? or they just lose their position for a bit then they fade into the set Pt position?

i mean they do their position reset whenever I turn them on. then lets say I want them to go to the drums. They go to the drums but then if I want them to go to the keys and I press the keys scene instead of just fading to that position they fade to their home position then to they keys scene. but they do not stop at the home position they just fade into them home position and continue to their next destination. Usually the same thing for tilt

Hi, do you have a fade out time in use? Try it with 0 fade out time, cause i think that it is fading out to your home position and then going to the position you clicked on.

Ok I figured out the problem. Apparently something was wrong with the fixture settings thanks

Instead of smoothly going to the commanded position occasionally the Pan motor moves in sharp jerks a few degrees at a time in the correct direction. Pan belt looks good. No error messages. DMX input remains static. Unit seems to recover when the pan motor gets to the desired position. Any ideas?

greetings, could be the main board or sensor (optical/magnetic) inspect the board first and look for any damage. if ok reseat all the connectors and recheck. please note we discontinued parts and support for the original 5R spots

We have six (6) of these fixtures installed since 2017, and have recently sent all 6 back to Elation for repair (had two started dying within weeks of each other, so just sent all 6 in to have the identical replacement process done preemptively). three (3) of the six came back from Elation with their "home" position 90 degrees off (the yoke perpendicular to the menu screen), while the others remain as they were (home is yoke parallel with the menu screen). Console/control is JandsVista V3 A...

@elationservice Any suggestions would be welcomed!

When starting up my elation fuze wash z120 fixture it gets stuck in a pan, has a lot of noise and is not controllable. It does this most times (not all the time) and it doesn't matter if it is connected to dmx or not. I took it to service but they could not help. What to do? Does anyone hva experience with this problem. My fixture has had it since it was new...