Tagged With "Pulsing"

Hi, I am using an ETC Element console sending sACN through a switch to an Elation Enode 4, which in turn is outputting DMX to a wireless transmitter for the LED's in our rig. I've gone through all of the network set up, but after plugging everything in and powering it on, the LED's started pulsing at 1s intervals. I do have control the LED's, but the pulsing doesn't stop. I've tried several different variations of wiring including taking the switch out of the equation entirely and running...

Have you tried using a different port, or do all the ports act the same? What firmware version does your Enode 4 have installed? Have you tried using Art-net to test if Enode responds to it?

Yes, I tried multiple ports. I did briefly try Art-net but I'm unfamiliar with it, and after I changed the settings I couldn't even ping a signal between the board and the node. I am currently looking into that to see if I can get it to respond.

I believe the firmware version is 2.3.

If you have the uploader below, you could try updating the firmware to V2.4. https://www.elationlighting.com/sni-software-uploader

Thanks. I just got it working using Art-Net. I had to change the broadcast mode to Primary Art-Net, set the Art-Net start universe at 0, and set the LED's to Art-Net & DMX in the interface section of the patch.

Ok, so my firmware is already V2.4. However, when I went to double check that just now, I could no longer control the LED's. All of the settings and everything were still the same, they just weren't coming on. I've changed the broadcast setting to Limited Broadcast and keep checking periodically to see if it's still working. Any suggestions? One thing I did notice was that when I changed the settings to Primary Art-net the IP and Subnet on the board changed, but not the gateway. The node...

hi Shawna can you give us a call when you are infront of the node.. please call 323-213-4593. this will ring directly into support.

Hi, what was the solution to Shawna's problem? I have connected an eNode 4 to my ETC Nomad. I have control, but the same pulsing occurs. I have the network settings set at sACN, not Artnet.

Upload tool: C-Loader Pulse Bar L Firmware V1.03 What's new: Resolved bugs: 1) Network sACN random Flicker 2) When screen lock is enabled, self-test mode freezes. 3) When set to all control parameters of RGB strobeline, it should switch to CW Strobe control. You should not attempt uploading the firmware to the fixture unless you have read and fully understand the instructions that came with the relevant Fixture firmware uploader for your fixture. Clicking this link will take you to the...