Skip to main content

Got a couple little issues,
First, my 3d visualizer only will show green or white beam and says gobo 1, 2, etc. but doesn't show the pattern.
Second, I have 4 ADJ Vizi Spot LEDs, and I can't seems to get them to move opposite of each other. Like when I use my XY axis, I set each fixtures to cross each other, it shows up correct on 3D(except color and gobo) but then all fixtures only point to the 1st fixtures position on the XY. Also my phasing/chase does the same thing, works on 3d, but all fixtures strobe in sync for the chaser. I am thinking this is a fixture profile issue because I do have to manually change the shutter to open when I am adding the fixtures in order to get any light during the test screen. Oh I have the December 2010 software I believe.
Original Post

Replies sorted oldest to newest

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×