Ok so I have a scenesetter 48. We use it to control our lighting for our plays at school. In the past we have only used it to run them manually. Just turn up what sliders we need for different scenes. This year our lighting scheme is a lot more complicated so we decided to program the show. So last night we read all the directions. Watched a youtube video on how. Programmed a short practice program and then programmed our 50 steps for our show. We followed the directions from the manual and it seemed to be working fine. We ran it a couple of times after we programmed it. Turned it off then back on and it still worked. Then today we went to start the program and nothing. Any ideas? I'm desperate, our show is Friday and it is really hard to keep up with the lighting on the fly. Thanks in advance for any advice.
Original Post

Add Reply

Likes (0)
Post
×
×
×
×