Fresh out of the box Elation Design Spot 250 Pro. First power. Ran through startup tests. Got all sorts of errors and the fixture would not run. Opened base cover and saw the first (closest to edge) fuse blown. Replaced with a new one of same type. Just a few errors. Swapped the replaced fuse with the one that wasn't replaced (second fuse holder on board. Everything but Focus works. I'm going to replace the other fuse as well. I have limited time to get in to do this as it's at church and I am employed elsewhere.
Question: Better to send in if I still get that error or should I check the magnets and connecting cables first? I don't mind getting into the box. I'm in AZ so it'd be easy to call during your working hours.
Original Post