I have a few lights that i want to set up a few switches for. I would like these switches to just activate these lights and fade up to, lets say 100% blue.
So i went to the page settings for that page of lights. and enabled fade on all of them. semi tricky here as i at first thought that by enabling fade would do it for ALL on that page however i found out that you have to enable it on every fixture on that page.
So i did everything i thought i was supposed to but evidently i missed something because not only do they not fade in (they just pop on to 100%)but afterward when strobing or chasing them the first on the address string is now off sync with the others when i chase or strobe them.
Any ideas here?
Thanks
Mark
Original Post