Elation Fuze Pendant

Hello the instructions provided in the manual are pretty accurate, make sure the pinch bolt is completely backed out (but no removed) otherwise the lid will not close flush. also make sure the lens is properly seated in the output hatchportion of the pendant.

The problem we have, it does not seat in there because of the rubber around the lens.

can you please email me a picture.. send to parts@elationlighting.com

https://youtu.be/rCON3m-e-7Y

@saylorville posted:

https://youtu.be/rCON3m-e-7Y

Hi, if you can also email that video link to the email Gines posted above, someone would get back to you faster than on the forums. Thanks!

I emailed the same time I posted in the forum.

I did. Same time that I posted it.

OK great thanks!

We are also having problems opening the lens cover:

Hello, the 3mm pinch bolt is still making contact with threaded portion, please unthread a little more and you may have to slightly pry on the Allen head portion in order to clear the Threaded portion

We have the bold screwed all the way out. So pry on the bolt head to pull further back?

Not sure that you can. There’s no way of really grabbing a hold of that bolt and pulling it out more because it’s screwed into something which I’m assuming must be some plastic or something. I tried open the one and I got it, but it was not easy. I’ve had to fight three or four more.

Do you have a chart that helps set color mixes that match different kelvin ranges? For example, if I want the lights to be 3200K, what mix of LEDs in DMX would I set?