I'm having some issues with the colors on a Geni Shiva 250R. When using the pre programmed buttons some colors will be half and half. I've tried to build my own profile but I'm getting stuck. I'm just not able to figure out how to program the channel rages into the profile. Is there something I'm missing? I'll go to add the dimmer function and it will have the full range of values. Then if I add anything else it just cuts down the values not letting me assign a specific range to that function...I hope that's understandable.
I'm using 4 250R's and have also tried setting up just one light to see if it was an multi light issue. I guess it would be important to add that not every light has the same color issue. lights 1,2,3 might be OK and 4 would be stuck half and half or a different color. Is my only option to "fine tune" the settings on each color for every fixture? Any help would be greatly appreciated!
This setup is for my church and until I picked up this project they barely used the system. Right now we have 15 PAR 64's...4 Shiva's...6 Mania's...10 LEDS...4 Color Fusions. We also have the house lights running through the system. Were are a growing church with lots of potential. I would just like some help to bring some of that potential to light ;-)
Original Post
