One of my DS 575Es stopped spinning or indexing after having the whole gobo module out to put in some new gobos. The gobos still spin while the gobo wheel is rolling to the next gobo, but will not respond to control. Any ideas?
Original Post
Replies sorted oldest to newest
make sure your connectors @ the module are properly seated. if it worked before it should be fine.
Took the module out and checked all of the visible motor and sensor connections in the module. I put the module back in and now the Gobo won't spin or index AND the color selection wheel now shimmies and moves randomly into different colors and will not respond to control. I checked and double-checked the 4 connectors that connect the module to the head. I checked the numbers (JOB, JOA, etc.) I looked very carefully for bent pins or any anomaly and then carefully seated them into the correct strips. The connector strips seat deeply enough that it is difficult to get a fingernail under to pry them off again.
What could I be missing?
What could I be missing?