Skip to main content

In This forum you can discuss tips, tricks, and troubleshooting for Elation's Next Generation Compu Live software, "Compu Show".

I have some LED strip fixtures that look really good but have a bad dimmer curve. From DMX 0-127 it feels like 0%-10% brightness... and from 192-255 it approaches 100% very rapidly. It makes manual fades look very jerky, and even EasyTime sequences are too exaggerated.

I can't use a linear min/max dimmer because even at say DMX level 64, you can see a slight amount of light. It's not truly off until nearly 0, but it's definitely not 50% at 127. So I need to use the whole range of 0-255, just translate it.

Is it possible to apply a curve to this somehow to make the end result more linear? Either in the fixture profile or... page patch...?

Thank you!
-Adam
Original Post

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×