Equipment Compatiability for Church Lighting

Hello

I am working with a local church regarding some new lighting and have a few questions.

I am looking at the following lights:

-Elation KL Fresnel 6 150W 3000K

-Elation KL Fresnel 4 50W 3000K

Four of the 6" Fresnels across the front. Two 4" Fresnels for backlighting the main speaker and another two 4" Fresnel for additional lighting.

My main question regards controlling theses lights. The church uses the following for lighting control:

-ADJ DP-DMX20L 4 channel Dimmer Packs (qty4)

-Stage Setter-8 Fader control board.

Will this equipment work together? If not, what would be a solution for lighting control? I do see where the lights will stand alone in a sort of "set it and forget it" mode. Is this correct? Open to any thoughts or suggestions.

Thank You

Attachments

Hide

Images (2)

6/16/238:52 AM

❤️ 0

Original Post

Replies sorted oldest to newest

Jingles8302Admin

Hi, these KL series of fixtures cannot be run off of a dimmer pack, or at least the ones you mentioned cannot. they need their own power source that is outside of the edison plugs on the DP-DMX20L. and they will have to be wired into DMX in the chain as new fixtures.

6/16/2310:54 AM

❤️ 0

Neal EvansMember

Thank you for your response.

So, just to be clear. Fixtures need to plug straight into AC with the powerCON/Edison adapter. DMX just daisy chains through the lighting fixtures. DMX addresses each fixture directly. Correct?

6/16/2312:27 PM

❤️ 0

Jingles8302Admin

That sounds correct to me, yes.

6/16/234:10 PM

❤️ 0