In This forum you can discuss tips, tricks, and troubleshooting for Elation's Next Generation Compu Live software, "Compu Show".

I am switching from Show Designer 2 to Compushow with Midicon so I'm looking to set it up similar to SD2 but I'm having several issues.

1. I'm wanting to setup the separate wheels to control my pan/tilt speed and gobo rotation speed to be used on the fly. So far I have only been able to use them when that specific attribute is highlighted. I want to be able to use them simultaneously, is that a possibility?

2. After I assign the data wheels the only way to actually control them is with a dimmer round slider not a speed round slider.

3. I'm also looking to setup some preset button pan positions for my yokes but be able to adjust the tilt on fly with the third data wheel. What would be the best way to configure/program this? I'm looking for just pan values and no tilt values so I can add and adjust tilt values on the fly.

Thanks for all the help getting me up to speed!
Original Post

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×