I just changed the internal battery in my sd2..now my lcd wont come on. double checked to make sure all the cables were plugged in...my work light will come on..but that's about it. I have a gig coming up in a few days and need to get this looked at..or suggestions to try first!
Original Post
It's probably the cable. If you unplugged it, it might be off a pin or partially seated. Sometimes it comes loose when you open it up.
Then maybe the new battery is causing a problem. I've never heard of that happening but that's what is different from when it was working.
Ok..now it's working. Kind of Confused After replacing the battery it apparently dumped the memory and I get the message memory locked when trying to choose a fixture. can I reload the memory via the cf card? never had much luck finding a nullo cable.
First, erase all the memory (see manual). If you have a good backup on CF card, reload it. If not you will have to start over.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×