hi
i searched through the forum and are looking for some profiles. where can i download profiles for:
-American DJ: Mighty Spot
Chauvet: Intimidator 2.0
Martin: CX-2
thank you so much for the help
Original Post
Replies sorted oldest to newest
http://www.americandj.com/Prod...elligent_Controllers
As you can see the Magic 260 is supported by American DJ. you might want t0 call them and ask for support for the Magic 260. They should be able to help you in no time. Also i have never heard of a Mighty Spot from ADJ. Just the mighty scan.
Sincerely,
As you can see the Magic 260 is supported by American DJ. you might want t0 call them and ask for support for the Magic 260. They should be able to help you in no time. Also i have never heard of a Mighty Spot from ADJ. Just the mighty scan.
Sincerely,
i meant mighty scan.mistake on my side.i found 'em. thanks so much james. if i have more questions i let u know. i am still new to all this.mostly used the board with pre-programmed stuff but never did it myself.
i got another question.
can i use 1 dmx cable and use it on 2 controllers? the magic 260 for my intelligent lights to run the shows and then i have a dmx operator and use that for all my conventional lights (cans and blinders).i would like to split the cable and use different addresses.
also,can the auxiliaries be used as a bump on the magic 260?
thanks so much
can i use 1 dmx cable and use it on 2 controllers? the magic 260 for my intelligent lights to run the shows and then i have a dmx operator and use that for all my conventional lights (cans and blinders).i would like to split the cable and use different addresses.
also,can the auxiliaries be used as a bump on the magic 260?
thanks so much
Never use a dmx-Y Cable. You cannot split the dmx chain the way you just described. you would need to run 2 cables one from your magic to those lights and one cable from the DMX Op to those lights being controlled by the op. If you use a dmx y cable you may damage your lights and the controller.
Sincerely,
Sincerely,