My Stage Setter 8 has blown it's little fuse and I'm unable to decipher the writing on it to determine the amperage. Can you tell me what a replacement fuse should be? Thanks in advance.

Steve
Original Post
Yep, that's what I guessed it would be, but blew through three 1A fuses to verify it... Checked the power supply and it seems fine for voltage and amps. Just ordered the replacement board for $20 so hopefully that will be the fix. Thanks for the link.

Steve
OK, I received the replacement board today (thanks) and it powers up without blowing the fuse each time (an improvement), however the board you sent is ver. 1.3 and my board was ver. 1.1 (sigh).

So, the connecting cable doesn't fit.

http://www.stevenragatz.com/temp/lightboard.jpg

The new board is on top and has the grey socket. The older board on the bottom allows for the current cable to attach.

Question: Is there a cable that I can get to replace the one that is in my unit or do I have to try to wire it myself?

Steve
Hello Steven,

did you order this part online or by phone? If you ordered it by phone, please provide the phone number that was given, if you did it online, please provide the order number and I will look into this for you. Thanks. My email address is JoelChen@americandj.com

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×