Art-Net

In This forum you can discuss tips, tricks, and troubleshooting for Elation's Next Generation Compu Live software, "Compu Show".

cbabbmanMember

I'm having some difficulties getting Artnet to be enabled.

While I am running Sunlight, I believe they are virtually the same and I see quite a bit more activity here than on the Nicolaudie site... please don't hold it against me..lol

I an running Sunlite Suite 2 - FC so I have 4 Artnet universes available to me. I've followed all the directions for setting artnet in the output devices.

Whenever I follow the directions by turning off auto detect and choosing artnet and closing the output device setup, I receive the following error message:

Warning Hardware Detection.
Interface found but not set up in the DMX patch
SUITE2 FC Serial: <my serial#> ip : xxx.xxx.xxx.10

What am I missing?

Also, do we have the ability to set the IP address to something we want or are we limited to 2.xxx.xxx.xxx?

Thanks..

10/12/1310:27 AM

❤️ 0

Original Post

Replies sorted oldest to newest

cbabbmanMember

OK, I finally got this working, with the assistance of Simon... (Thank you!)

What the manual and videos don't tell me is that I had to to have 2 items in the Output Hardware list:

The USB or USB/Ethernet Interface as well as Artnet.

My problem was self induced because I didn't look close enough at the hardware list and had put the USB Sunlite FC interface (which I don't have) in rather than the USB/Ethernet Sunlite FC (which is what I have)..

10/15/1310:29 AM

❤️ 0

Former Member

cbabbman,

unfortunately this forum is for elation and Antari products only. for any sunlite questions you might have your best bet would be to contact them for information.

10/15/1311:14 AM

❤️ 0

cbabbmanMember

ah... but since they are basically the same program, there is a wealth of information here that is helpful and very applicable to users of both programs...

It's unfortunate that outside of both this forum and the Nicolaudie forum, and the few youtube tutorials available, there really isn't much information or help to be had on this software, so I appreciate and use both of them to get the maximum benefit.

10/15/131:19 PM

❤️ 0

Skip to main content

Add Reply

Membership Required

Remove From Your Block List

Manage Follow Preferences

Block

Please wait...