Skip to main content

Firmware Tool Required: A-Loader (SNI211)

Protron Eclypse Firmware V1.5

What's new:

  • The flickering image on 16bit master channel
  • Using duration and rate set at 255 in manual mode to get a steady output
  • Use only 75% of max output power in manual mode.

You should not attempt uploading the firmware to the fixture unless you have read and fully understand the instructions that came with the relevant Fixture firmware uploader for your fixture. Clicking this link will take you to the Software uploader section of our website so you can pick the correct uploader tool for your needs and fixtures. If you do not see your fixture listed, please contact

Last edited by Jingles8302
Original Post

Add Reply

Link copied to your clipboard.