Ceiling

jerryMember

If I am using 1024 compu ware and I setup a switch to do circles on the dance floor. I set the paramaters to the size I want by using the x/y in the settings. Then I want a switch to show on the ceiling with circles but larger circles. How do I get the circles on the ceiling larger than the x/y settings I set for the dance floor.

Does one x/y control all the switches/scenes or do I set each switch/scene in the settings for the size I want? Hope this makes sense.

I want the ceiling much larger than the circle on the floor.

4/19/109:56 AM

❤️ 0

Original Post

Replies sorted oldest to newest

Jingles8302Admin

If you adjust the X and Y parameters in the page settings then you are adjusting the pan and tilt globally for moving heads on that page. So there would be no way in the scene edit window with the EFX generator to make them larger as the software is telling the pan and tilt "Nope, we can't go that far" Make sense? You can undo this by going back into the page settings and re adjusting the parameters. Let me know if this helps Jerry.
Sincerely,

4/19/1010:47 AM

❤️ 0

jerryMember

I think I understand, but if I go back and readjust the settings then the circles on the dance floor will be much larger also, correct.

4/19/1011:45 AM

❤️ 0

Jingles8302Admin

I believe so. This is why you always got to think one step ahead when you program your fixtures.
Sincerely,

4/19/1012:03 PM

❤️ 0