Design Spot 250 problems

I opened up another fixture and Im getting error codes: 9,3,5,8,1,13,06,07,08 and now its flashing a495 on the screen

hello, on the first unit check the fuses located on the main PCB. the main pcb is located directly behind the display.

regarding the 2nd unit with the multiple errors.
it sounds like you may have an issue with the wire harness. please remove the covers and inspect. BTW A495 is the DMX address the unit was set to.

Best regards.
Gines Gines
Elation service manager

on the 2nd unit could the pcd board be bad?

its possible. where these by chance flooded units that you purchased?

quote:

Originally posted by service g:
its possible. where these by chance flooded units that you purchased?

Yes they were

ok, well this explains everything. i would caution you on repairing flooded units. first all stepper motors need to be inspected since typically they will rust. then all pcb need to be replaced regardless. this is the starting point.

Let me know.

Best Regards,
Gines Gines
elation service manager

how much would it cost to have them shipped in? and What would be estimated repair?

the starting estimate fee would be about 35.00 then we would call you with a revised estimate.
if you would like too send them in please email me your information. service at elation lighting . com

The units do not move, plugged in or not, so all steppers are fried.

at that point i would caution you on purchasing parts. between the cost of all the PCB, the stepper motors, and (maybe) any PSU. it would be cheaper to purchase a new or preowned unit.

Gines Gines
Elation service manager.