I am having lots of problems getting this controller to work. I have followed the instructions as per the manual but get no output to the lights.
I am using a variety of intelligent lighting and I have set the dmx addresses on the lights according to the channel block diagram in the manual. I followed the instructions to set the joystick controls then continued the assigning fixture to output. I have 4 Martin scx 700 scanners all set to address 1 and want them all on one channel. I have 4 CX10 Exremes 2 FOR ONE CHANNEL AND 2 FOR A SEPERATE CHANEL, 2 EFX600s FOR ONE CHANNEL, and 4 Dj Traximus LaSERS 2 ON ONE AND THE OTHER 2 ON THEIR OWN INDIVIDUAL CHANNELS. Seems pretty basic USING UP ALL 8 CHANNELS. When doing this though the fixtures don’t respond…. I am missing something somewhere. Is there a programming video for newbies that can visually step people through the setup process.
I know the fixtures are set properly and I know the cables are ok (cables were on our other system and it worked) We have THE 4 lasers that we cant seem to figure out the binary to set the address properly that are in the daisy chain… but even just hooking up one fixture to the board doesent seem to get any response…. I have played with it for 5 or 6 hours and cant seem to get it.
Can someone there help a newbie work through this problem?
Original Post