Skip to main content

Upload Tool: SNI Software Uploader

eNode 8 PRO V1.12 firmware (VERSION 1 ONLY!)

THIS FIRMWARE IS FOR ENODE 8 PRO VERSION 1 UNITS ONLY! If you are not sure, contact us at the email listed below.

Release notes:
Devices should not do a full broadcast to 255.255.255.255, but rather to 2.255.255.255

RDM Support.

Instructions for uploading Enodes

You should not attempt uploading the firmware to the fixture unless you have read and fully understand the instructions that came with the relevant Fixture firmware uploader for your fixture. Clicking this link will take you to the Software uploader section of our website so you can pick the correct uploader tool for your needs and fixtures. If you do not see your fixture listed, please contact Firmware@elationlighting.com

Last edited by Jingles8302
Original Post

Replies sorted oldest to newest

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×