Skip to main content

In This forum you can discuss tips, tricks, and troubleshooting for Elation's Next Generation Compu Live software, "Compu Show".

So I used to have the rig set up where I had some pan/tilt swaps. Doing this was causing some of my beams to be off in relation to the others. I now have no swapping going on and the beams are looking even now.

So now on to some movement programming questions. Having the swap when I ran circles I liked that half the rig would be turning clockwise and the other half counter clockwise. With the swap off, this is no more. How do I get this look without the swap? Thanks again!
Original Post

Replies sorted oldest to newest

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×