Skip to main content

I am operating lights at our church have a SD2CF with a variety of RGB36s and Design Spot 250s. I am also trying to control the house lighting through a RMD-620 dimmer pack. I have the unit installed and have DMX signal to it, but I have no control. The Elation rep that I purchased the equipment from installed a profile for DP-640 to run the dimmer pack. As a relative newbie to this world, I have no idea if this is correct or not. All I know is that the house lights are not responding to my commands. Any help would be greatly appreciated.
Original Post
Audia,
I just saw this post.. are you still having issues?
It sounds as if you need some DMX help over there.
Using the fixture patch you should have the address of the fixture in the SD2 match the address of the dimmer..
If you not sure what the address is, the address is a 3 digit number that dimmer must have.. then a fixture button on the console should have the same 3 digit number.
If these numbers don't match then you wont get any response. If you can't figure it out then we will need to get a local lighting guy to come in and help you out.
Where are you located?

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×