Thank you for letting me Join this Forum. I am new to the lighting community.
I am using a Pro Designer II. When I hook my focus spots at the end of my run the last light bar starts flashing, and when I program the lights into the controller I can get them to move (up, down, side to side) with 3 channels but get no response from the other channels (no lights). I have not tried a booster yet but don't know if that will help with the control of the light? Thank you for you time.
Original Post
you should be able to use the rest of the faders to open the shutter and dimmer, if you are not getting light output, check the fixtures lamp to make sure it is on or try striking the lamp from the SD2 via the DMX traits.
Sometimes it helps to have the manual with the DMX chart handy as you program.

Add Reply

Likes (0)
Post
×
×
×
×